Remove Door To Fix Lock

If there is paint on the lock face then when you remove the mechanism the paint may stick to the lock face and peal off the wood of the door.

Remove door to fix lock.

One night after getting ready for bed a person walks up to the main door of his house to lock it and pulling up on the handle he feels and almost hears the slight almost imperceptible resistance in the german manufactured locking mechanism of the latch. When you are trying to figure out how to fix a door lock that is jammed it is necessary to stay patient to avoid causing further damage. Loosen and remove the screws that hold the strike plate at the face of the door jamb with a screwdriver. 1 8 3mm drill bit.

If you do not have a proper broken key extractor you can use a jigsaw blade or a pair of tweezers. Slide the screwdriver around the perimeter of the door panel until you hit one of the hidden clips. Once triggered the lever or lock trim can be removed from the door. Scratch awl or similar pointy tool.

A broken key extractor is one of the easiest ways how to fix a door lock that is jammed in this way to open. The actuator will slide off two rails. 3 32 2 4mm drill bit. Take off the plate and save the screws and plate.

Scratch awl or similar pointy tool. Look on the neck of the inner doorknob. If the latch does not reach the strike plate shim out the plate or add another strike plate on top of it remove the screws and run them through both plates. 2 cut the bead of caulking at the vertical.

Before you remove the lock mechanism from the door you may want to score the gap around the lock front with a razor to free any paint that may be attached to the metal. How to remove a door knob with hidden screws step 1. Open the door so that you can access both the inner and outer doorknobs. If any screws are exposed during this process remove them to release the lock and remove it from the door.

When you find one pull straight out on the screwdriver to disengage it. Then jam another flat blade screwdriver between the latch and the actuator and pry. If the latch still will not reach shim out the door s hinges. Straighten a paper clip and insert it into the hole.

Replace the plate fill the gap at the top or bottom with wood putty and refinish. Apply a bit of pressure to the paper clip to trigger a release button inside the hardware.