Remove Jeep Doors With Power Windows

With the other hand grip the outside door handle.

Remove jeep doors with power windows.

Instructions 1 remove the door panel. The first step in the removal of jeep doors is to loosen and remove the t50 cap nuts on the door hinges. Heavy duty connectors are installed allowing doors to be removed. Simple 3 wire hookup.

Once you ve removed the nuts reach through the open window to grip the inside door handle. Remove the nuts on the bottom of each bolt. 2 pull or cut out the glued door seal to allow access inside the door. Use a 13 mm socket and turn counter clockwise to loosen the nuts.

Roll down the windows remove the door check arm unplug the wiring drop the two hinge bolts pull off the limit strap and lift it free. 3 on a manual window use the crank to roll down the window halfway to give you access to the bolt that. At the bottom of each of the two bolts that hold each door on the. If you need more information on how to do that check out the door panel removal video.

The nuts are painted to match the body of the jeep so be very. Lift the door straight up to disconnect it. The process is basically the same for the front and rear. One power wire goes to the battery one goes to an ignition power source and the third gets grounded in the kick panel.

It s also beneficial to lube the door stems and hinges when the doors are removed in order to make future removal easier. Be careful not to damage the paint. Be careful with the paint on the door hardware. This can be done with a t50 socket and ratchet.

See more information on our jeep wrangler power window kit power door lock kits.